User's Manual

11
5. Operating XU/XV-100 RADIO
5.1 On/Off/Volume Control
Turns the radio on and off and adjusts audio volume level.
5.2 PTT Button(Push-To-Talk Button)
Radio transmission button.
5.3 Menu Button(P, Program Menu Button)
Enter into Menu mode by pressing the Menu button (P) for 2 seconds.
The sequence of menu mode is as follows.
→ → → →
Compander → Change Group → ID → Scramble → Squelch
→
→ →
→ KEY Sound → VOX → Lone Worker
5.4 Monitor Button(M)
The monitor mode is enabled and disabled by pressing the Monitor button (M) on the side.
Normal Mode : During pressing the (M) button for about 2 seconds, it is possible to check the receiving status.
Continuous Mode : During pressing the (M) button for more than 2 seconds, the Radio will make a “Beep”
tone, which means the monitor function is maintained and if you press the (M) button again, the monitor
function will be released.
5.5 Emergency Button
In case of emergency situation, if you press the Emergency button, a siren sound will be heard through the
speaker in the Radio and the Radio will transmit the emergency signal to the party through the emergency
channel.
5.6 Channel Buttons(▼,▲)
Channel Buttons(▼,▲) have 3 functions as shown in following.
1 Channel buttons(▼,▲) are to change channels.
2 Channel buttons(▼,▲) are to select menu at menu mode.
3 Channel buttons(▼,▲) are to change transmission power. By pressing Up button(▲) while PTT button
is being pressed, the user can select ”H”(High Power), or by pressing Down button(▼), the user can
select ”L”(Low Power).