User's Manual

Ffigure 6-9) ID Transmission

3 After the call is completed, the Transmission and the Reception have no restriction, which means

that the TX/RX will be free.

2) 2) Group(1:N) Call at call mode

1 In order to make the Group call at the call mode, the following should be set up at the PC

programming.

2 If the 1

party (ID:53579) and the 2

party(ID:52468) are in one group, the "5AAAA"which is a call

number / call name(example : baseball player) should be designated. ("A" means that all the numbers

are applied.)

3) If the caller makes a call to the group of baseball players, the caller’s Radio should press the “Menu” and

“▲” buttons at the same time after selecting the party with ID “1AAAA”. In this case, the Radios of the

party1 and the party2 display the ID "1AAAA". In case of the group call, the party’s Radio displays the

group ID number.

After the call is completed, the Transmission and the Reception have no restriction, which means that

the TX/RX will be free.

Figure 6-10) Group Call

3) RESET

This Reset function converts the TX/RX with no restriction to the previous Close mode. Press the Monitor

button (M) at the call mode.

1 The call signal will be transmitted to the party’s Radio with the ID number + “C” tone.

2 If the party’s Radio is in the Close channel and after receiving the call with the “C” tone, the call is

converted to the “TX/RX with no restriction” mode.