User's Manual

3) RESET

This Reset function converts the TX/RX with no restriction to the previous Close mode. Press the

Monitor button (M) at the call mode.

① The call signal will be transmitted to the party’s Radio with the ID number + “C” tone.

② If the party’s Radio is in the Close channel and after receiving the call with the “C” tone, the

call is converted to the “TX/RX with no restriction” mode.

6.9 Emergency Call function

(Optional depending on operating service and radio programming)

1) This Emergency call is used for calling the party in emergency and if pressing for about 2

seconds the button in Red color on the top side of Radio, the Emergency Call is transmitted.

In case of setting to the emergency call channel (available by PC programming) with your ID at

the general mode or if the Radio is in the call mode, you can make an Emergency Call by

pressing the button in Red color for about 2 seconds.

The transmission is sent with the “C” tone after your ID number.

① The party’s Radio receives the “C” tone along with your ID number. The Radio recognizes it

as an emergency call and displays your ID number with the consecutive alarm sound.

2) Without transmitting the emergency call to the party, the Radio itself makes the emergency call

sound continuously.

6.10 STUN function

(Optional depending on operating service and radio programming)

The Radio is lost or in case you don’t want someone to use your Radio, the reception of STUN ID

saved in the Radio protects the Radio from the use by someone.

(The Stun ID can be set up by PC Program.) If the STUN ID is saved in the Radio, the Radio can’t

be used even after the power off & on of Radio. After receiving the UNSTUN ID, you can use the

Radio.

Figure 6-11) STUN Screen