User Manual User Manual

ManualsBrandstekmar ManualsRelay480 User Switch

U 480

06/06

tekmarNet

4 User Switch 480

- User Brochure

Table of Contents

User Interface ......................................................... 2

Scenes .................................................................... 2

Setpoint Controls .................................................... 3

Error Messages ...................................................... 4

Warranty ................................................................. 4

The User Switch

allows for easy and

convenient control of your tN4

heating and cooling systems.

By pressing a single button, you

can:

•

• Activate a night setback on

the tN4 heating and cooling

system.

•

• Activate an away override.

•

• Activate custom programmed

system overrides.

•

• Activate and deactivate devices

such as hot tubs and radiant

floors.

The user switch also allows for

optional remote access through

a third party telephone switch,

security system, or automation

system.

User

Button

User

Button

User

Button

Summary of content (4 pages)

PAGE 1
- User Brochure U 480 06/06 tekmarNet®4 User Switch 480 Table of Contents The User Switch allows for easy and convenient control of your tN4 heating and cooling systems. By pressing a single button, you can: User Interface ......................................................... 2 Scenes.................................................................... 2 Setpoint Controls .................................................... 3 Error Messages ......................................................
PAGE 2
User Interface • • • • Each button is labeled according to the feature that it is programmed to activate. When a button is pressed, the button turns green and the programmed feature activates. Pressing the button while it is green deactivates the programmed feature. In some cases, the installer may have disabled a button. In this case, when the button is pressed, the button will not turn green. • Each button can be programmed to activate or deactivate a Scene or a Setpoint Control.
PAGE 3
Example A user switch has been installed together with two thermostats. The thermostats are located in the master bedroom and the guest bedroom. In this example, when a guest arrives to stay the night, the “Guest” button can be pressed and the Guest Bedroom temperature will operate on a programmable setback schedule. User switch button 1 is labeled “Normal”. Once the guest leaves, press the “Normal” button to lower the Guest Bedroom to the unoccupied temperature setting.
PAGE 4
Error Messages If a single button begins to flash red, the user switch is unable to communicate to a setpoint control. Contact your installer to correct this condition. User Button 1 User Button 1 User Button 2 User Button 2 User Button 3 OR User Button 3 User Button 1 OR User Button 2 User Button 3 User Button 1 If all 3 buttons begin to flash red together, the user switch can no longer communicate to the rest of the tN4 controls. Contact your installer to correct this condition.