Installation Guide

4 of 12
© 2016 tekmar 518
_
D - 06/16
Mounting The Thermostat
Wall
Thermostat
Front
Thermostat
Base
If mounting directly to the wall:
• Drill holes using a 3/16" drill bit and install the wall anchors.
• Feed the wiring through the large hole in the thermostat base.
• Fasten the thermostat base to the wall using the wood screws to the wall anchors.
• Terminate wiring to the wiring strip. Do not over tighten wiring screws. Hand
tighten only.
• Push the thermostat front onto the thermostat base.
3
1
/4”
(83 mm)
Stud
Gang
Box
Thermostat
Front
Thermostat
Base
Adapter Plate 012
If a single gang box is used:
• Adapter Plate 012 is required (sold separately).
• Feed the wiring through the hole in the adaptor plate and the thermostat base.
• Fasten the adaptor plate to the gang box.
• Fasten the base of the thermostat to the adaptor plate.
• Terminate wiring to the wiring strip. Do not over tighten wiring screws. Hand
tighten only.
• Push the thermostat front onto the thermostat base.
To prevent the risk of personal injury and/or death, make sure power is
not applied to the thermostat until it is fully installed and ready for final
testing. All work must be done with power to the circuit being worked
on turned off.
Please be aware local codes may require this thermostat to be installed
or connected by an electrician.