User Manual

Use a #19 drill bit or
4mm reamer to ream
arms until hinge pin
falls through freely.
Stock Position
(”B” Block)
Stock Position
(”A” Block)
30.2
TKR1601
TKR1601
TKR1601
TKR5086
TKR5482 - 2.5mm
TKR5086
Install the sway bar ball onto the
sway bar wire until the end of
the wire is ush with the ball as
picture above.
Loosen the M3x4 set screw
(TKR1601) if
the anti-roll bar
does not
turn freely.
Note: Do not over-tighten
TKR1601
TKR5165
TKR1522
TKR1522
TKR1522
M3x8mm Cap Head Screw
x2
Bag J
Front End
*TKR5480 - 2.3mm
*TKR5481 - 2.4mm
*TKR5483 - 2.6mm
*TKR5484 - 2.8mm
*TKR5485 - 3.0mm
(Option)
Thread
Lock
Thread
Lock
13
TKR1327
TKR1333
M3x40mm Flat Head Screw
x2
TKR1238
M4x10mm Droop Screw
x2
TKR5049A
Pivot Ball Sway Bar
x2
TKR5079A
Stabilizer Ball
x2
TKR1529
M3x20mm Cap Head Screw
x2
TKR1327
M3x16mm Flat Head Screw
x2
TKR1333
TKR1238
TKR1529
TKR5020
TKR1601
M3x4mm Set Screw
x6
Step
J-1
Step
J-2
Step
J-3
TKR5162
TKR5161
TKR5436
TKR5056
TKR5149A
TKR5165
TKR5165
Note: With these stock settings,
Kick Up = 8.5° / Arm Sweep = 0°
For reference, with center dot
inserts in both braces,
Kick Up = 10° / Arm Sweep = 0°
TKR5079A