User's Guide

Meeting Room Display Tablet User Guide T0006377_UG Version 0.5
TEKTELIC Communications Inc. Confidential Page 16 of 28
Figure 3-2: Tablet back side
3.6 Battery Replacement
The following tools are required to install the Meeting Room Display Tablet:
1) A Philips Screwdriver (#2)
2) 4x AA batteries (LiFES2 – Energizer, part number: L91)
Steps for replacing the batteries are as follwos:
 Removed the battery cover by removing two philips screws shown in Figure 1-3
 Remove all the old batteries from the device.
 To turn off the device the batteries must be uninstalled and remain un-powered for 1
minute.
 Replace with all new batteries of the recommended type.
 Install the battery cover and philips screws to secure the batteries.
 See section 5.3 for LED behaviour during boot-up.
 Recycle the used batteries when possible by dropping them off at a participating
reatiler.