User's Guide
Gen2 BLE Sensor Family User Guide T0006940_UG_Mobile Version 1.0
TEKTELIC Communications Inc. Page 17 of 31
2 Installation
2.1 Included Product and Installation Material
The following items are shipped with each sensor:
1x sensor inside an enclosure with 3.6 V AA-cell or C-cell LTC battery installed.
1x corresponding sensor Quick Start Guide.
1x mounting bracket (only for variants with mounting).
1x small magnet (only for C-cell variants).
2.2 Safety Precautions
The following safety precautions should be observed for all Gen2 sensor variants:
All installation practices must be in accordance with the local and national electrical
codes.
Replace only with approved batteries (see section 2.6).
The following sensor variants are intended for indoor use only: T0006779, T0006905,
T0007128, T0007378, T0007379, T0007380.
The Sensor contains an LTC AA-cell or C-cell battery. When used correctly, lithium
batteries provide a safe and dependable source of power. However, if they are misused
or abused, leakage, venting, explosion, and/or fire can occur. The following are
recommended safety precautions for battery usage [3].
Keep batteries out of the reach of children.
Do not allow children to replace batteries
without adult supervision.
Do not insert batteries in reverse.
Do not short-circuit batteries.
Do not charge batteries.
Do not force discharge batteries.
Do not mix batteries.
Do not leave discharged batteries in
equipment.
Do not overheat batteries.
Do not weld or solder directly to batteries.
Do not open batteries.
Do not deform batteries.
Do not dispose of batteries in fire.
Do not expose contents to water.
Do not encapsulate and/or modify batteries.
Store unused batteries in their original packaging away
from metal objects.
Do not mix or jumble batteries.
2.3 Unpacking and Inspection
The following should be considered during the unpacking of a new sensor.
1. Inspect the shipping carton and report any significant damage to TEKTELIC.
2. Unpacking should be conducted in a clean and dry location.