User's Guide

Kona Micro User Guide T0005281_UG Version 1.3
TEKTELIC Communications Inc. Page 8 of 25
2. Installation
2.1. Overview
• The Kona Micro Gateway is intended for indoor use only.
• The Kona Micro Gateway has no internal field serviceable parts other than the battery. Other
than installing or replacing the battery, the Gateway module must only be opened by an
approved TEKTELIC service center.
• All installation practices must be in accordance with the local and national electrical codes.
• Ensure that the Kona Micro Gateway is located to eliminate any physical hazard to people or
property.
• The Kona Micro Gateway shall be powered from the supplied AC-DC power adaptor.
• Do not cover the Gateway or in any way obstruct airflow through the enclosure openings.
• The Kona Micro Gateway may as an option contain a built-in battery. The Gateway may
continue to operate after the DC power connection is removed. To completely power down
the Gateway when optional battery backup is present, both the DC power source and the
battery must be disconnected.
• If the battery needs replacement, use only a replacement battery provided by Tektelic
Communications Inc. After battery installation, ensure that the battery cover is secured using
the supplied battery cover securement screws. Dispose of old batteries in accordance with
regulatory requirements.
2.2. Unpacking and Inspection
The following should be considered during the unpacking of a new Kona Micro Gateway.
1. Inspect the shipping carton and report any significant damage to TEKTELIC.
2. Unpacking should be conducted in a clean and dry location when possible.
3. Do not discard the shipping box or foam inserts as they will be required if a unit is returned
for repair or re-configuration.
2.3. Kona Micro Gateway Mounting
Kona Micro Gateway can be placed on a flat surface or can be mounted to a wall with M3
screws to locations on the back of the module illustrated in Figure 3.