User's Manual

Remote Commands
C-40 GB1400 User Manual
Output (Clock and Data) Setup Commands
amplitude [v]
Amplitude. This command sets both Data and Clock amplitudes to the same voltage [v].
Min. Abbr. am
Arguments v: <NR2>, in the range 0.50 to 2.00 in steps of 0.05.
Example amplitude 1.50
amplitude?
Amplitude Query. Returns two message units, the first indicating the clock
amplitude setting and the second indicating the data amplitude setting.
Min. Abbr. am?
Returns <NR2>, <NR2>
Example amplitude?
(command)
CLOCK_AMPL 1.450; DATA_AMPL 1.450 (response)
clock_amp_up and
clock_amp_dn
Clock Amplitude Up/Down (Default). This command pair is used to increment or
decrement the current clock amplitude setting by the default increment of 0.05 volts.
Min. Abbr. clock_amp_u
clock_amp_d
Arguments none
Example clock_amp_up
clock_amp_dn