User's Manual

Remote Commands
GB1400 User Manual C-69
auto_thresh [n]
Auto_Thresh. Sets the Error Rate Threshold used when Auto Search is in BER mode.
This the exponent for the error rate used for the Delay settings, in terms of 10E-n
Arguments n: 3 to 10
Example auto_thresh 3
auto_thresh?
Returns the exponent of the number used as the Data Delay Error Rate Threshold.
Response <NR1 Numeric>
auto_width?
Returns the Width of the Data Eye as determined by Auto Search, in either mode. These
values are in terms of seconds. (Example, 100E-12 is 100 pS.) The following delay error
codes are returned if appropriate:
1 Only 1 Data Eye Crossing found
2 No Data Eye Crossing found
3 Auto Search not run
Response <NR1 Numeric>