User's Manual

Pattern Editing Software
H-2 GB1400 User Manual
Minimum Requirements:
Microsoft Windows 3.1 or later running on a 386 or faster machine with 4 Mb of
memory, For reasonable speed, a 486 DX or DX2 with at least 8 Mb of memory.
At least 2 Mb of free hard disk space.
gB700 Tx or Rx with 128K memory.
gB1400/1600 Tx or Rx with at least 256K memory.
A PB200.
One free RS-232 port or a National Instruments GPIB card with associated driver
and software.
List of Features
• Editing capability in excess of 1 Mb. File size is in increments of 1 bit.
• Files can be displayed, edited, and saved in Hex, Decimal, Octal, or Binary
formats.
• Data can be saved or displayed LSB (Least Significant Bit) or MSB (Most
Significant Bit) first.
• Files saved in one format can be converted to any of the other three formats.
• Multiple editing windows can be open simultaneously to allow working on
several files at once.
• The editor runs under Microsoft Windows with full Windows printing
capability.
• Extensive built-in help.
• Data can be uploaded to a gB700/1400/1600 Tx or Rx via RS-232 or GPIB.
• Uploaded data can be saved in any memory location for any memory
configuration, even while the instrument is performing tests.
• Data can be downloaded from a gB700/1400 Tx or Rx via RS-232 or GPIB.
Downloaded data can be saved to disk for safe keeping or later editing, even
while the instrument is performing tests.
• Data can be saved to disk and read from disk in a format compatible with the
PB200, both current single file per disk and future multiple files per disk
formats.
• The editor has full cut, paste, and copy facilities along with a last action
delete UNDO.
• The editor has full find and replace functions.
• Replaced data can be a different length than the data it is replacing.
What the editor cannot do: