LAN Adapter User Manual AD007

Getting Started

AD007 User Manual

Setup Procedure 2 - Stand-Alone Operation

If the following conditions are true, you can manually set up the

adapter to work with a stand-alone PC.

H You want to set up the adapter apart from a network.

H The stand-alone PC does not have the appropriate settings and

connections to access the web pages on the adapter.

NOTE. Stand-alone operation requires a PC 10/100BaseT Ethernet

card and an Ethernet hub, crossover cable, or crossover adapter.

(The crossover cable or adapter is specifically designed for

connecting two nodes without a hub.)

To set the IP address in the adapter, do the se steps:

1. Disconnect any ca ble that is currently connected to the adapter.

2. Power on the adapter and wait for the self test to complete. After

the self test is complete, the following states apply:

GPIB LAN LAN-Link POWER

-- -- -- -- -- -- -- -- -- -- ( 3 0 s e c o n d s e l f - t e s t , l i g h t s b l i n k a m b e r ) -- -- -- -- -- -- -- -- -- -- --

-- -- -- -- -- -- -- (Self test pass, indicators momentarily blink green) -- -- -- -- -- -- --

Off Off Red Green

3. Locate the reset button on the bot tom of the ada p ter. (For the

location of the reset button, see Figure 11 on page 48.)

4. Using a small tool or end of a paper clip, momentarily push in the

reset button. This action loads the last known IP address. (For a

new adapter, the last known address is the factory default IP

address of 192.168.1.1.)