User's Manual
Install Your Instrument
2 AWG5000 Series Quick Start User Manual
Operating Requirements
Power Supply Requirements
Cleaning
Inspect the arbitrary waveform generator as often as operating conditions require. To clean the exterior surface, perform
the following steps:
1. Remove loose dust on the outside of the instrument with a lint-free cloth. Use care to avoid scratching the front panel
display.
2. Use a soft cloth dampened with water to clean the instrument. Use an aqueous solution of 75% isopropyl alcohol for
more efficient cleaning.
1. Place the instrument on a cart or bench,
observing clearance requirements:
■ Top: 20 mm (0.8 in)
■ Left and right side: 150 mm (5.9 in)
■ Bottom: 20 mm (0.8 in)
■ Rear: 75 mm (3 in)
2. Before operating, ensure that the
ambient temperature is between 10 °C
and 40 °C (+50 °F to +104 °F).
CAUTION. To ensure proper cooling, keep sides of the instrument clear of obstructions.
AWG
5014
1.2 GS/s
Arbitrary Waveform Generator
Analog Analog Mkr 1 Mkr 2 Analog Analog Mkr 1 Mkr 2 Analog Analog Mkr 1 Mkr 2 Analog Analog Mkr 1 Mkr 2
Channel 1 Channel 4Channel 3Channel 2
DO NOT APPLY EXTERNAL SIGNAL
!
Amplitude
Marker 1
Marker 2
Offset
DC
Output
-3 V to +5 V
100 mA
Panel
Lock
HDD
Sampling Rate
Timing
File
Level
All Outputs
ABC
E
D
F
Channel
High
High
Low
Low
Bksp
DeleteCancel
Enter
Open
Save
Factory Default
Touch
Screen
On/Off
897
T/p
4 6
G/n
123
M/
Ch
Ch
3
Ch
Ch
3
Ch
3
0
/
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
Event
Input
Trigger
Input
Force
Event
Force
Trigger
14
CAUTION
TURN OFF OUTPUTS
BEFORE CHANGING
CABLES OR
POWERING DUT.
!
5V
RMS
!
O
f
f
O
f
f
On
On
On
On
On
On
Ch
Ch
2
Ch
Ch
2
Ch
2
Ch
Ch
1
Ch
Ch
1
Ch
1
Run
Run
Run
Run
Run
Run
GND
465 mm
(with handle)
245 mm
Source Voltage and Frequency 100 VAC to 240 VAC, 47 Hz to 63 Hz
Power Consumption Less than 560 W
WARNING. To avoid personal injury, power down the instrument and disconnect it from line voltage before performing any
of the following procedures.
CAUTION. To avoid damage to the surface of the arbitrary waveform generator, do not use any abrasive or chemical clean-
ing agents.