Datasheet

Ethernet 10/100/1000BASE-T Application Software — TDSET3 • SR-ENET • DPO4ENET
SR-ENET Ethernet Triggering and Analysis Test
Characteristics
Instrument Compatibility
Oscilloscope
Description
All models of
MSO/DPO5000,
DPO7000C, and
DPO/DSA/MSO70000C/D/DX
Series
10BASE-T and 100BASE-TX
Bus Setup Options
Option
Description
Ethernet
Compatibility
10BASE-T, 100BASE-TX
Sources
Analog channels 1-4
Math channels 1-4
Recommended
Probing
Differential
Address/Data
Formats Available
Hex
Binary
Hex or ASCII: Data
Mixed: Hex or ACSII data, other fields in decimal and hex.
Bus Decode
Option
Description
Ethernet Data
Rates
10BASE-T: 10 Mb/s
100BASE-TX: 100 Mb/s
Decode Display
Start of Packet (green bar)
Preamble (blue packet)
Start of Frame Delimiter (blue packet)
MAC Destination and Source Addresses (yellow packets)
MAC Length/Type (blue packet)
Data (cyan packet)
IPv4 Header (white packet)
TCP Header (brown packet)
Frame Check Sequence/CRC (purple packet)
End of Packet (red bar)
Error (red packet)
Internet Protocol
Support
IPv4
Transport Layer
Protcol Support
TCP
Display Modes
Option
Description
Bus
Bus display on/off
Event Table Decoded packet data in a tabular view
Bus Trigger Options
Option
Description
Trigger
*
and/or Search On 10BASE-T:
Start Frame Delimiter
MAC Addresses: Trigger on Source and Destination 48-bit address values
MAC Q-tag Control Information: Trigger on Q-tag 32-bit value
MAC Length/Type: Trigger on ,<,=,>,,  a particular 16-bit value, or inside or outside of a range
MAC Client Data: Trigger on ,<,=,>,,  a particular 16-bit value, or inside or outside of a range. Selectable number of bytes to
trigger on from 1-16. Byte offset options of Don't Care, 0-1499
IPV4 Header: Trigger on IP header 8-bit value, Source Address, Destination Address
TCP Header: Trigger on Destination Port, Source Port, Sequence Number, and Ack Number
TCP/IPv4 Client Data: Trigger on ,<,=,>,,  a particular data value, or inside or outside of a range. Selectable number of bytes to
trigger on from 1-16. Byte offset options of Don't Care, 0-1499
End of Packet
FCS (CRC) Error
100BASE-TX:
Start Frame Delimiter
MAC Addresses: Trigger on Source and Destination 48-bit address values
MAC Q-tag Control Information: Trigger on Q-tag 32-bit value
MAC Length/Type: Trigger on ,<,=,>,,  a particular 16-bit value, or inside or outside of a range
IPV4 Header: Trigger on IP header 8-bit value, Source Address, Destination Address
TCP Header: Trigger on Destination Port, Source Port, Sequence Number, and Ack Number
MAC Client Data: Trigger on ,<,=,>,,  a particular data value, or inside or outside of a range. Selectable number of bytes to
trigger on from 1-16. Byte offset options of Don't Care, 0-1499
TCP/IPv4 Client Data: Trigger on ,<,=,>,,  a particular data value, or inside or outside of a range. Selectable number of bytes to
trigger on from 1-16. Byte offset options of Don't Care, 0-1499
End of Packet
FCS (CRC) Error
Idle
*
Ethernet triggering available on MSO/DPO5000 Series only
www.tektronix.com 7