User's Manual

Removal and Installation Procedures
MTG100 & MTG300 MPEG Generator Service Manual
6Ć35



    
    
    
  
  
Figure 6Ć16: Power supply unit removal
4. Remove the 5 V Power supply: See Figure 6-17.
a. Unplug the two cables at the connectors on the power switch and one
cable at CN1 on the 12 V Power supply.
b. Using a screwdriver with a size Phillips #2 tip, remove the four screws
securing the 5 V Power supply to the bracket.
5. Remove the 12 V Power supply: See Figure 6-17.
a. Unplug the cable from the 5 V Power supply.
b. Using a screwdriver with a size Phillips #2 tip, remove the three screws
securing the 12 V Power supply to the bracket.
6. Remove the Power switch: See Figure 6-17.
a. Unplug the four cables from the power switch.