User Manual

Installation
3. Install the sid
e brackets () over the posts on the side of the rackmount tray
() using the hex nuts with lock washers (). Lightly tighten the nuts so that
the side brackets can slide enough to allow for adjustment when installing the
assembly in the rack.
4. Remove the front side screws or plugs from the appropriate side of the
instrument. For example, to install an instrument on the left side of the
rackmount tray, remove the front side screws or plugs from the left side of the
instrument.
The following list describes which screws or plugs to remove, by instrument:
FCA/MCA instrum ents: Remove both plugs from the appropriate si de of
the instrument.
DMM instruments: Remove the one center screw adjacent to the handle
mount hole from the appropriate side of the instrument.
PWS instruments and AFG2021: You do not need to remove any screws
from the power supply instruments or the AFG2021.
5. Place the instrument on the side of the rackmount tray where you want the
instrument. If you are installing only one instrument, position the instrument
on the left side of the rackmount tray. Position the instrument on the
rackm
ount tray so that the front instrument side screw holes align with the
holes on the front side of the rackmount tray.
6. Attach the front side of the instrument to the rackmount tray using the
appropriate screw or screws. (See Figure 1 on page 4.)
RMU2U Rackmount Kit 7