User's Manual

TDS1000/2000-Series Digital Oscilloscope User Manual

151

Appendix A: Specifications

All specifications apply to the TDS1000- and TDS2000-series

oscilloscopes. P2200 probe specifications appear at the end of this

chapter. To verify that the oscilloscope meets specifications, the

oscilloscope must first meet the following conditions:

H The oscilloscope must have been operating continuously for

twenty minutes within the specified operating temperature.

H You must perform the Do Self Cal operation, accessible t hrough

the Utility menu, if the operating temperature changes by more

than 5° C.

H The oscilloscope must be within the factory calibration interval

All specifications are guaranteed unless noted “typical.”

Oscilloscope Specifications

Acquisition

Acquisition Modes Sample, Peak Detect, and Average

Acquisition Rate,

typical

Up to 180 waveforms per second, per channel (Sample

acquisition mode, no measurements)

Single Sequence Acquisition Mode Acquisition Stops After

Sample, Peak Detect Single acquisition, all channels

simultaneously

Average N acquisitions, all channels

simultaneously, N is selectable

from 4, 16, 64, and 128