User Guide

Command Descriptions
Syntax
FACtory
Setting the oscilloscope to factory d efault has the following impact on the
programming interface:
Clears the Event Status Enable Register
Clears the Service Request Enable Register
Sets the Device Event Status Enable Register to 255
Sets the Power On Status Clear Flag to TRUE
Enables all Command Headers (HEADer ON)
Sets the macro definedby*DDTtoa"zero-lengthfield"
Clears the pending operation flag and associated operations
Performs the equivalent of DATA INIT
The FACtory command does not change the following items:
State of the RS-232, GPIB, or USB interface
Selected GPIB address
Front panel LOCK state
Verbose state
Display Brightness, TPS2000 Series onl
y
Display Contrast, TDS1000, TDS2000, TDS1000B, TDS2000B, and
TPS2000 Series
Calibration data that affects device specifications
Stored settings
Stored waveforms or data
Hard copy parameters
Display messages language selection
Current page of paged menus
SAVE:IMAGE:FILEFORMAT
FILESYSTEM:CWD
Related Commands
*PSC, *RCL, RECAll:SETUp, *RST, *SAV, SAVe:SETUp, SAVe:IMAge:
FILEFormat,
Examples
Refer to Appendix B: Factory Setup
2-76 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer