Datasheet
Probe Power Supply
1103 Datasheet
1103 TekProbe Power Supply.
Features & Benefits
1103
Powers up to Two Probes
For Use with P6205, P6243, P6245 , P6246, P6247, P6248 , P6249,
P6330, P6701B, P 6703B, P5205, P5210 , ADA400A, and TCP202 on
other th
an TekProbe BNC Interfaced Scopes*
1
Overload Protected 1103
Applications
High-speed Digital Systems Design
ECL
GaAs
MOS: CMOS; FastCMOS; BiCMOS; TTL
Component Design/Characterization
Amplitude levels
Aberrations
Propagation Delay and Timing
Bandw
idths and Rise Time s
Educational Research
Manuf
acturing Engineering and Test
TekProbe BNC™ Interface
The 1103 is an accessory power supply that provides external power to
TekProbe BNC Interface probes. The 11
03 allows customers to use probes
requiring TekProbe interfa c e power with any oscilloscope or digitizer that
does not provide TekProbe BNC power.
The 1103 offers two independently controlled channels consisting of a
TekProbe BNC interface input, a voltage offset control (p roviding variable
offset or no offset) and BNC signal output.
The offset control supplies a voltage, adjus table via the front panel control.
This offset control is available for TekProbe BNC probes with this capability.
These include: P6235, P6245, P6246, P6247, P6248, P6249, and P6330.
*
1
The characteristics for TekProbe BNC Interface probes are subject to change when used with the 1103
TekProbe Power Supply. Bandwidth, Rise-time, Propagation Delays will generally differ from the advertised
probe only specification. These are dependent upon: 1) the cable length from the output BNC connector to
the oscilloscope input, 2) the instrumentation input impedance the output BNC is being connected to, and 3)
any additional adapters required to properly interface to the test instrumentation.
To use TekProbe BNC Interface probes on the 11800, CSA800, TDS8000, CSA8000 or any non-TekProbe BNC
interface test instrumentation requires an 1103 TekProbe Power Supply, an SMA Male to BNC Female
adapter, a 50 Ω BNC cable and if required a 50 Ω feedthrough termination.
Characteristics
Output Voltage ±2% – +15 V, -15 V, +5 V, –5 V.
Output Current – 300 mA.
Outputs – Pin 1: n.c.
Pin 2: n.c.
Pin3:+5V.
Pin 4: +15 V.
Pin5:Offset±1V.
Pin6:–5V.
Pin 7: –15 V.
Power Consumption – ≤35 W.
Physical Characteristics
Dimension
cm
in.
Depth 17.8
7
Width 15.8 6.2
Height 8.9 3.9
Weight kg lb.
Net 1.8 3.9