User's Manual

Reference: Remote Commands ~ Command Description
OTS9100 User Manual 3-63
:SOURce:MEASure:HDLC:FRAMes
This query returns the value of the specified result parameter.
Syntax :SOURce<slot>:MEASure:HDLC:FRAMes? <Parameter>
Parameters Description
GPCS Count of HDLC frames transmitted with good FCS
BFCS Count of HDLC frames transmitted with bad FCS
:SOURce:MEASure:HDLC:FRAMes:ALL
This query returns the values of all of the parameters of the :SOURce:MEASure:HDLC:FRAMes?
Syntax :SOURce<slot>:MEASure:HDLC:FRAMes:ALL?
:SOURce:MEASure:IP:PACKets
This query returns the value of the specified result parameter.
Syntax :SOURce<slot>:MEASure:IP:PACKets? <Parameter>
Parameters Description
TOTal Total count of transmitted IP packets
GOOD Count of good transmitted IP packets
BAD Count of IP packets transmitted without errors
:SOURce:MEASure:IP:PACKets:ALL
This query returns the values of all of the parameters of the :SOURce:MEASure:IP:PACKets?
Syntax :SOURce<slot>:MEASure:IP:PACKets:ALL?
:SOURce:OUTPut:LASER
This command enables or disables the Transmitter's output laser. The query returns the current setting.
The laser, when turned on, takes some time to reach operating conditions; during this time, the query
returns INITIALIZING.
Syntax :SOURce<slot>:OUTPut:LASER?
:SOURce<slot>:OUTPut:LASER <Enum>
Parameters Description
OFF Set laser off
ON Set laser on
INITializing The laser is initializing (query response only)