Operation Manual

15
GB
5.12 Diffuser Display
The diffuser has a display which also
incorporates the remote control IR receiver.
When the red Power light (Fig. 20 ref. A) is lit
on the display the air conditioner is powered
off 230 Vac line power.
When the green Run light (Fig. 20 ref. B) is
lit, the air conditioner is working in Cold
mode; if the red Run light is lit, the air
conditioner is working in Heating mode.
The two figures (Fig. 20 ref. C) normally refer
to the ambient temperature measured by the
air conditioner inside the camper.
During the required temperature setting
procedure with the remote control, the display
unit will show the currently selected
temperature; after approximately 30 seconds
from the end of the selection procedure, the
display will show the camper indoor
temperature again.
5.13 Cleaning the filters
Periodically clean both diffuser filters: wash
with a neutral detergent only and dry them
thoroughly before putting them back in their
seats (fig. 21).
5.14 Timer setting
• Press the TIMER key on the remote
control: the start time ON indicator is
activated
• By using the +HOUR and –HOUR keys,
set the start time
• Press the TIMER key once again: the stop
time OFF indicator is activated
• By using the +HOUR and –HOUR keys,
set the stop time
• Press the TIMER key once again
• After completing the setting operations,
press the SET key
To delete timer programming press the
CLEAR key
The start and stop
times are programmable in 10 minutes'
steps.
5.15 Operation without remote control
If the remote control is lost or not working, it
is still possible to use the air conditioner by
delicately pressing with a sharp object the
small Reset key hidden inside the slot next to
the display (Fig. 22).
By pressing the key, the air conditioner is
started in the automatic mode, automatic fan
mode, temperature setting 24 °C.
22