User's Manual

Latching relay function

LATCHING RELAY FUNCTION

In some Operating Modes you can assign a latching

function to certain relays (see description of Operating

Modes). Latching means that the relay is activated every

time a button is pressed, but remains active until the

button is pressed again. You can set this on the receiver

using the FUNCTION button and the SELECT button.

1. Use the FUNCTION button to switch between the 3

function LEDs:

A. the red code storing LED

B. the yellow latch LED

C. the green interlocking LED

2. Stop at the latch LED and select it by pressing the

SELECT button. The latch LED will go out. The red LED

above relay 4 will light up.

3. Use the SELECT button to select the relay that you want

to assign a latching function. Press the FUNCTION button

to light up the latch LED. If the latch LED is already lit and

the red LED above a relay lights up, this relay has already

been assigned a latching function. To remove the latching

function from a relay, press the FUNCTION button once,

so that the latch LED goes out.

4. To assign latching to more relays, use the SELECT button

to select the next relay that you want to assign a latching

function to. The receiver will exit the code storing mode

after 10 seconds idling.

B CA