User's Manual
Table Of Contents
- Chapter 1: CUSTOMER INFORMATION
- Chapter 2: SAFETY INFORMATION
- Chapter 3: PRODUCT PAGES
- Chapter 4: INSTALLERS GUIDE
- Navigate in menu mode
- Enable PIN codes
- Create PIN codes
- Erase PIN codes
- Show registered PIN codes
- Start the transmitter in operating mode
- Start the transmitter in operating mode with PIN codes
- Turn the transmitter off
- Login/logout
- Register
- Erase
- Replace
- Automatic shutdown
- Frequencies & channels
- Relay functionality
- Digital inputs
- Chapter 5: OPERATING MODES
- Chapter 6: LOAD SELECT MODES
- Chapter 7: BATTERY GUIDE
- Chapter 8: CERTIFICATIONS CHAPTER
TG-RX-MNLCAN,TG-RX-MNRCAN,TG-RX-MNPCAN,TG-RX-
MNLJ1939,TG-RX-MNRJ1939,TG-RX-MNPJ1939BASEBOARD
RECEIVERWITHCANEXPANSIONBOARD
WARNING! The receiver must NOT be opened by any other than a qualified installer. Make sure to
turn the electricity off before opening the receiver.
WARNING! Tele Radio remote controls are often built into wider applications. We recommend that
the system is provided with a wired emergency stop where necessary.
Base board:
1. LED representing stop relays 1+2 (red) 8. Antenna connector
2. Stop relays 1+2
9. Function LEDs 1-4 (1= red, 2= yellow, 3=
green, 4= orange)
3. Obligatory fuse 2A (slow) 10. Function button (Cancel)
4. Terminal block for input power 11. Terminal block for mixed I/O
5. Function relays 1-7 12. Select button (OK)
6. Relay LEDs 1-7 (red) 13. Programming connector
7. Function LEDs 5-7 (5= red, 6= yellow, 7=
green)
14. Power LED (yellow)
- 17 -