User's Manual
Table Of Contents
- Chapter 1: CUSTOMER INFORMATION
- Chapter 2: SAFETY INFORMATION
- Chapter 3: PRODUCT PAGES
- Chapter 4: INSTALLERS GUIDE
- Navigate in menu mode
- Enable PIN codes
- Create PIN codes
- Erase PIN codes
- Show registered PIN codes
- Start the transmitter in operating mode
- Start the transmitter in operating mode with PIN codes
- Turn the transmitter off
- Login/logout
- Register
- Erase
- Replace
- Automatic shutdown
- Frequencies & channels
- Relay functionality
- Digital inputs
- Chapter 5: OPERATING MODES
- Chapter 6: LOAD SELECT MODES
- Chapter 7: BATTERY GUIDE
- Chapter 8: CERTIFICATIONS CHAPTER
ERASEPINCODES
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.The LEDs light (green when the battery capacity is good, red when
the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The LEDs light (green when the battery capacity is good, red when the battery capacity is poor) when in
menu mode.
6. Go to [PIN] --> [Erase PIN].
7. Scroll the list to select the PIN code that you want to erase.
8. Select by pressing the left start button.
9. Confirm by pressing the left start button.
SHOWREGISTEREDPINCODES
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Go to [PIN] --> [Show PIN].
7. The display shows a list of all registered PIN codes.
- 32 -