Installation Instructions
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Safety
- Chapter 3: Functional safety
- Chapter 4: Technical data
- Chapter 5: Product general description
- Chapter 6: Boards description
- Chapter 7: Status and error indications
- Chapter 8: Operation
- Chapter 9: Configuration menu
- Chapter 10: Warranty, service, repairs, and maintenance
- Chapter 11: Regulatory information
- Annex A: Glossary
- Annex B: Index
2.1.2OPERATION
Only qualified personnel should be permitted to access the transmitter
and operate the equipment.
l Make sure that the user satisfies the age requirements in your
country for operating the equipment.
l Make sure that the user is not under the influence of drugs, alcohol
and medications.
l Make sure that the user knows and follows operating and
maintenance instructions as well as all applicable safety procedures
and requirements.
The user should:
l Always test the transmitter stop button before operating it.This test
should be done on each shift, without a load.
l Never use a transmitter if the stop button is mechanically
damaged.Contact your supervisor or representative for service
immediately.
l Never leave the transmitter unattended.
l Always switch the transmitter off when not in use. Store in a safe
place.
l Keep a clear view of the work area at all times.
2.1.3MAINTENANCE
Before maintenance intervention on any remote controlled equipments:
• always remove all electrical power from the equipment.
• always follow lockout procedures.
l Keep the safety information for future reference. Always download the
Installation instructions from our website, www.tele-radio.com, for the latest
available version.
l If error messages are shown, it is very important to find out what caused
them. Contact your representative for help.
l The functionality of the stop button should be tested at least after every 200
hours’ use.
10 IM-PN-RX107-CERT-01pre4
PRELIMINARY