Installation Instructions
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Safety
- Chapter 3: Functional safety
- Chapter 4: Technical data
- Chapter 5: Product general description
- Chapter 6: Boards description
- Chapter 7: Status and error indications
- Chapter 8: Operation
- Chapter 9: Configuration menu
- Chapter 10: Warranty, service, repairs, and maintenance
- Chapter 11: Regulatory information
- Annex A: Glossary
- Annex B: Index
1. Terminal block for power supply
(PWR)
1
, stop relays (SR) and
function relays (R)
2. Connector for input power
2
3. Stop relays SR1–2
4. Connector for 48–230VAC
5. Connector for 12–24VAC/DC
6. Connector for 12–24VDC
3
7. Function relays 1–10 (NO)
8. Connector for expansion board
4
9. Connector for DO 1–2
10. Connector for expansion board
TR507
5
11. Connector for expansion board
6
12. Connector for expansion board
7
13. Power LED (yellow)
14. TRABUS contact
15. Radio module (TR362)
16. Function LEDs
(1 = red, 2 = yellow, 3 = green, 4 =
orange)
17. Connector for expansion board
8
18. PLd status LED (red)
19. Function button (cancel)
20. Select button (OK)
21. Status LEDs for digital outputs 1–2
(red)
22. LED indicators for stop relays
SR1–2
23. Relay LEDs 1–10 (red)
6.1.1CONNECTOR FOR DIGITAL OUTPUTS ON THE BASEBOARD
1. +5V
2. Digital output 1
9
3. Digital output 2
4. GND
1
By design, input power (PWR) is also connected to connector J21.
2
To be connected to either J43, J44 or J45, depending on the voltage to achieve.
3
Input to be used when the receiver needs to be able to go low in voltage.
4
RS485
5
CAN/J1939
6
Digital inputs (not in use for the moment).
7
Big relay board (not in use for the moment).
8
Relay/DO/+12V
9
Open drain, max. voltage 30V, max. current 100 mA
26 IM-PN-RX107-CERT-01pre4
PRELIMINARY