Installation Instructions

CHAPTER 9: CONFIGURATION MENU
All configuration settings require access to the receiver circuit board(s).
RISK OF ELECTRIC SHOCK
The receiver must only be opened by qualified installers or authorized
personnel.
Make sure the power supply is switched off before opening the receiver.
Failure to follow these instructions could result in death, serious injury,
or equipment damage.
1. Remove the front cover of the receiver. Use a screwdriver to remove the
screws.
2. Power the receiver up.
3. The power LED lights (yellow).
4. Proceed with the configuration instructions of your choice.
9.1Menu mode
To access the different menus, press the Function button a predefined number of
times, according to the following table. The different menus are identified by the
function LEDs 1–4 (see "6.1 Base board").
: LED is lit. : LED is off.
Menu To access the menu,
press the Function
button…
Function LEDs light
LED 1
(red)
LED 2
(yellow)
LED 3
(green)
LED 4
(orange)
Register/ erase transmitters once
   
Show/ change Latching/
momentary functions
2 times
   
Show settings 3 times
   
Show/ change Operating
mode
4 times
   
Active Load select
(extended menu)
4 times then press
Select button once
   
IM-PN-RX107-CERT-01pre4 41
PRELIMINARY