Installation Instructions

9.5Active Load select
NOTE: If this setting is set to 0 (status LEDs 1–4 are off), the receiver will always
be activated when receiving a radio package. For all other settings, the receiver
will be activated when the load select on the transmitter corresponds to one of
the load select settings enabled in the receiver.
9.5.1SHOW/CHANGE LOAD(S)
1. Press the Function button 4 times.
Function LED 4 lights (orange).
2. Press the Function button for approx. 4 seconds or until function LEDs 3
(green) and 4 (orange) light. The receiver is now in extended menu mode.
Relay LEDs 1–4 show the current Load select setting according to the table
below:
: LED is lit. : LED is off.
Relay
LED 1
Relay
LED 2
Relay
LED 3
Relay
LED 4
the receiver will be activated when…
● ○ ○ ○
Load A is selected on the
transmitter
○ ● ○ ○
Load B is selected on the
transmitter
○ ○ ● ○
Load C is selected on the
transmitter
○ ○ ○ ●
Load D is selected on the
transmitter
○ ○ ○ ○
The receiver does not listen to any
load(s) and will always be activated
when receiving a radio package.
If no button is pressed within approximately 10 seconds, the receiver will
automatically exit the "Active load Select" mode and return to normal
operation mode.
To change Load select:
3. Press the Select button once.
Relay LED 1 flashes. Load A can be activated.
46 IM-PN-RX107-CERT-01pre4
PRELIMINARY