Instructions

Overview
CP150-OM-E Rev C 2-1
2Overview
DESCRIPTION
The CP150 uses a combination of Hall effect and transformer
technology which enables measurements to be made on AC, DC
and impulse currents. It has a 10 MHz bandwidth and is designed
to measure continuous peak currents up to 150 Amp.
The probe can be used with a Waverunner®, LC, or WavePro®
series oscilloscope with firmware 8.6.0 or higher. With the
ProBus® interface, the CP150 becomes an integral part of the
oscilloscope. The Auto Zero and Degauss functions are all con-
trolled from the oscilloscope front panel. The oscilloscope pro-
vides power to the probe, so no external power supply is needed.
KEY FEATURES
• Highly accurate current measurements
• Easy current measurements
• Large opening for high current measurements.
•Compact
• Over-current protected
CONVENTIONS USED IN THIS MANUAL
The following conventions may appear in this manual:
Note
A Note contains information relating to the use of the
product.
CAUTION
A Caution contains information that should be followed to
avoid possible damage to the instrument or the device
under test.
WARNING
A Warning alerts you to a potential hazard. Failure to
adhere to the statement in a WARNING message could
result in personal injury.