Data Sheet

DCCP
07/05
Local sales offices are located throughout the world.
To find the most convenient one visit www.lecroy.com
© 2005 by LeCroy Corporation. All rights reserved. Specifications subject to change without notice.
Other product or brand names are trademarks or requested trademarks of their respective holders.
Ordering Information
Description Product Code
30 A; 100 MHz Current Probe – AC/DC; 30 A
rms
; 50 A Peak Pulse CP031
30 A; 50 MHz Current Probe – AC/DC; 30 A
rms
; 50 A Peak Pulse CP030
30 A; 50 MHz Current Probe – AC/DC; 30 A
rms
; 50 A Peak Pulse AP015
150 A; 10 MHz Current Probe – AC/DC; 150 A
rms
; 500 A Peak Pulse CP150
500 A; 2 MHz Current Probe – AC/DC; 500 A
rms
; 700 A Peak Pulse CP500
Customer Service
LeCroy oscilloscopes are designed, built, and tested to ensure high reliability.
In the unlikely event you experience difficulties, our digital oscilloscopes are fully warranted for three years.
This warranty includes: • No charge for return shipping • Long term 7-year support • Upgrade to latest software at no charge
Related Products and Ordering Information
DA1855A – Differential Amplifier
The DA1855A high-performance
differential amplifier provides
100 MHz bandwidth, industry
l
eading overdrive recovery, and
outstanding common mode rejection ratio. The fast overdrive
recovery provides the ability to make critical saturation voltage
measurements while the high CMRR enables upper gate drive
measurements. Built into the DA1855A is a precision voltage
generator for offset far greater than the oscilloscope can provide
on its own. The DA1855A can be operated in true differential
mode or switched to comparator mode.
DCS015 – Deskew Calibration Source
To make accurate instantaneous power
measurements it is critical that both
the current and voltage waveforms be
aligned in time. The DCS015 calibration
source has both voltage and current time-aligned signals, which
enables the precise deskew of voltage and current probes. Most
voltage probes along with the AP015, CP015, CP030, and CP031
are compatible with the DCS015.
ADP300 and ADP305 –
Active Differential Probes
The ADP300 and ADP305 are high-voltage
differential probes ideal for measuring
p
ower electronics. The 20 MHz bandwidth
ADP300 is good for troubleshooting low
frequency power devices and other circuits
where the reference potential is elevated
from the ground or the ground is unknown. The 100 MHz
bandwidth ADP305 is designed for measuring the floating
voltages found in today’s high-speed power electronics.
PMA2 – Power Measurement
Analysis Software
The PMA2 software option is used to
make critical power switching device
measurements, perform control loop
modulation analysis, and measure
power harmonics. With PMA2, the
display and setup of voltage waveforms, current waveforms,
and necessary measurement parameters are done automatically.
Important device measurements like power losses, saturation
voltage dynamic-on resistance, and safe operating area are easily
performed. Pre-compliance testing to EN 61000-3-2 with easy-to
-read graphical and tabular pass/fail results is built in to PMA2.
Related Products
1-800-5-LeCroy
www.lecroy.com