User manual

Figure 4.107 - Data display right click menu
If you want to see only the numerical values, click on the Numbers Only icon on the Event Display
toolbar.
4.5.7.3 Switching Between ASCII, EBCDIC, and Baudot
On the Event Display window, the analyzer displays data in ASCII by default when you click on the Characters
Only icon . There are several ways to change the character set used to display data.
1. Go to the Format menu and select the character set you want. A check mark next to the character set
indicates which set is currently being used.
2. With the data displayed in characters, right-click on the data panel header label to choose a different
character set.
If you want to see only characters, click on the Characters Only icon on the Event Display toolbar.
4.5.7.4 Selecting Mixed Channel/Sides
If you want to get more data on the Event Display window, you can switch to mixed sides mode. This mode
puts all the data together on the same line. Data from one side (Slave ) is shown on a white background and data
from the other side (Master )is shown on a gray background.
1.
Click once on the Mixed Sides icon to put the display in mixed sides mode.
2. Click again to return to side over side mode.
3. You can right click in the center of the data display window to change between mixed and side over side
modes by selecting Display Sides Together. A check mark is displayed. Click on Display Sides
Together to remove the check mark and return to side-by-side display.
4. Right click in the sides panel on the right of the data display and select Display Sides Together. A check
mark is displayed. Click on Display Sides Together to remove the check mark and return to side-by-
side display.
TELEDYNE LECROY Chapter 4 Capturing and Analyzing Data
152 Frontline BPA low energy Hardware & Software User Manual