User manual

Figure 3.13 - L2CAP Decoder parameters tab
The L2CAP Set Initial Decoder Parameters dialog requires the following user inputs to complete a
Parameter :
l Stream - This identifies the role of the device initiating the frame (master or slave)
l Channel ID - The channel number 0 through 78
l Address - This is the physical connection values for the devices. Each link in the net will have an address. A
piconet can have up to seven links. The Frame Display can provide
address information.
l Data Source (DS) No. -When only one data source is employed, set
this parameter to 0 (zero), otherwise, set to the desired data source
number.
Carries (PSM) - Select the protocol that L2CAP traverses to from the
following:
l AMP Manager
l AMP Test Manager
l SDP
l RFCOMM
l TCS
l LPMP
l BNEP
l HCRP Control
l HCRP Data
l HID
l AVCTP
l AVDTP
l CMTP
l MCAP Control
Chapter 3 Configuration Settings TELEDYNE LECROY
Frontline BPA low energy Hardware & Software User Manual 25