User manual

l IEEE P11073 20601
l -Raw Data-
Adding, Deleting, and Saving L2CAP Parameters
1. From the Set Initial Decoder Parameters window, click on the L2CAP tab.
2. Set or select the L2CAP decoder parameters.
3. Click on the ADD button. The Initial Connection window displays the added parameters.
Figure 3.14 - Parameters Added to Decoder
4. To delete a parameter from the Initial Connections window, select the parameter and click on the
Delete button.
5. Decoder parameters cannot be edited. The only way to change a parameter is to delete the original as
described above, and recreate the parameter with the changed settings and selections and then click on
the Add button.
6. L2CAP parameters are saved when the template is saved.
3.2.3.2 L2CAP Override Decode Information
The Set Subsequent Decoder Parameters dialog allows the user to override an existing parameter at any
frame in the capture where the parameter is used.
If you have a parameter in effect and wish to change that parameter:
TELEDYNE LECROY Chapter 3 Configuration Settings
26 Frontline BPA low energy Hardware & Software User Manual