User Manual

12
PROBES
ZS Series High Impedance
Active Probes
ZS2500, ZS1500, ZS1000,
ZS2500-QUADPAK,
ZS1500-QUADPAK,
ZS1000-QUADPAK
The ZS Series probes provide high impedance and an
extensive set of probe tips and ground accessories to
handle a wide range of probing scenarios. The high
1 MΩ input resistance and low 0.9 pF input capacitance
mean this probe is ideal for all frequencies. The ZS Series
probes provide full system bandwidth for all Teledyne
LeCroy oscilloscopes having bandwidths of 1 GHz
and lower.
Differential Probes
(200 MHz – 1.5 GHz)
ZD1500, ZD1000,
ZD500, ZD200
High bandwidth, excellent common-mode rejection ratio
(CMRR) and low noise make these active differential
probes ideal for applications such as automotive
development (e.g. FlexRay) and failure analysis, as well
as wireless and data communication design. The ProBus
interface allows sensitivity, offset and common-mode
range to be displayed on the oscilloscope screen.
High Voltage
Differential Probes
HVD3102, HVD3106,
HVD3106-6M, HVD3206,
HVD3605, AP031
Low cost active differential probes are intended for
measuring higher voltages. The differential techniques
employed permit measurements to be taken at two points
in a circuit without reference to the ground, allowing the
oscilloscope to be safely grounded without the use of
opto-isolators or isolating transformers.
High Voltage
Passive Probes
HVP120, PPE1.2KV, PPE2KV,
PPE4KV, PPE5KV, PPE6KV
High voltage probes are suitable for a wide range of
applications where high-voltage measurements must
be made safely and accurately. There are several xed
attenuation probes covering a range from 1 kV to 6 kV
and varying transient overvoltage ratings. All of these
high voltage probes feature a spring loaded probe tip and
a variety of standard accessories to make probing high
voltages safe and easy. Additionally, all of the high voltage
probe have a probe sense pin to automatically congure
the oscilloscope for use with the probe.
Current Probes
CP031, CP031A, CP030,
CP030A, AP015, CP150,
CP500, DCS015, CA10
Available current probes reach bandwidths of 100 MHz,
peak currents of 700 A and sensitivities of 10 mA/div. Use
multiple current probes to make measurements on three-
phase systems or a single current probe with a voltage
probe to make instantaneous power measurements.
Teledyne LeCroy current probes enable the design and
testing of switching power supplies, motor drives, electric
vehicles, and uninterruptible power supplies.
Probe Adapters
TPA10, TPA10-QUADPAK
Probe adapters provide simple and easy interface of
third-party probes as well as change between the different
Teledyne LeCroy Oscilloscope input and cable types
(ProBus, ProLink, K/2.92 mm, BNC and SMA). Depending
on the adapters, changing between the Teledyne LeCroy
Oscilloscope’s input type may have an effect on the overall
performance of the channel.
The right probe is an essential tool for accurate signal capture and Teledyne LeCroy offers an extensive range of probes
to meet virtually every probing need.