Operators Manual Owner manual

HDO6000 High Definition Oscilloscope
System Status
The Utilities Status dialog displays information about your instrument including model number, serial
number, firmware version, and installed hardware and software options.
To view status, choose Utilities > Utilities Setup from the menu bar, then touch the Status tab.
OR
Choose Support > About from the menu bar.
The Utilities Status is not the same as the Status feature accessed through various menus. That feature
displays the current state of the oscilloscope configurations that affect the analysis functions--such as
acquisition, channel, parameter, function, and memory settings.
Remote Control Settings
The Utilities Remote dialog contains settings to configure remote control of the instrument. Supported
communication protocols are:
l TCPIP (Ethernet) - Enables remote control across a LAN via an Ethernet port. If you choose this
option, you also need to install Teledyne LeCroy's VICP drivers on the controller. These are included
in the VICP Passport plug-in, available free from teledynelecroy.com.
NOTE: The instrument uses Dynamic Host Configuration Protocol (DHCP) as its addressing
protocol. Therefore, it is not necessary to set up an IP address if your network supports DHCP. If it
does not, you can assign a static address in the standard Windows network setup menu on the
oscilloscope.
l LXI (Ethernet) - Enables remote control across a LAN via an Ethernet port.
l USBTMC - Enables remote control via a device connected to the USBTMC port.
l GPIB - Enables remote control using GPIB if you have the GPIB-USB adapter connected to any host
USB port.
98
922499 Rev B