Operators Manual Owner manual

Operator's Manual
Australia & New Zealand Declaration of Conformity– EMC
Oscilloscope complies with the EMC provision of the Radio Communications Act per the following
standards, in accordance with requirements imposed by Australian Communication and Media Authority
(ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in accordance with EN61326-1:2006
and EN61326-2-1:2006.
AUSTRALIA / NEW ZEALAND CONTACTS:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC Declaration of Conformity– Low Voltage
The oscilloscope meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and laboratory
use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 2-030: Particular requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following limits put forth by these
standards:
l Overvoltage Category II: equipment intended to be supplied from the building wiring with a nominal
supply voltage up to 300V.
l Measurement Category 0: oscilloscope measurement terminals that are not intended to be directly
connected to the MAINS supply.
l Pollution Degree 2: operating environment where normally only dry, non-conductive pollution
occurs. Occasionally a temporary conductivity that is caused by condensation must be expected.
This location is a typical office/home environment.
l Protection Class I: grounded equipment in which protection against electric shock is achieved by
basic insulation and a connection to the protective ground conductor in the building wiring.
U.S. NationallyRecognized Agency Certification
The oscilloscope has been certified by Underwriters Laboratories (UL) to conform to the following safety
standard and bears UL Listing Mark:
UL 61010-1 Third Edition – Safety standard for electrical measuring and test equipment.
922499 Rev B
131