Operators Manual Owner manual

HDO6000 High Definition Oscilloscope

Set Up Measurement Parameter

To configure custom measurements to add to the table of parameter readouts:

1. From the menu bar, choose Measure > Measure Setup.

2. Choose Measure Mode My Measure.

3. Touch the Pxtab or button of an unused location (or one that you want to change).

4. Select a Type:

l Measure On Waveforms- measures directly on the waveform selected as Source1.

l Math On Parameters - performs math (addition, subtraction, multiplication, division) on the

parameters selected as Source1 and Source2. These must be two other custom parameters you

have or will configure and saved to those slots.

l Advanced Web Edit - uses Teledyne LeCroy's Processing Web for measurement setup. This fea-

ture, available with the XWEB option, allows you to chain practically unlimited math functions for

operation on your waveform measurements.

5. Touch Source1 and select the channel, math trace, memory trace, or other waveform to be measured.

If using Math on Parameters, choose the parameters, rather than the source trace, in Source1 and

Source2.

6. If you selected Measure On Waveforms, touch the Measure field and select the parameter from the

pop-up menu.

7. Make any further selections on the right-hand dialogs that appear after your Measure selection.

These are explained on the dialog.

8. Optionally, set a measurement gate by dragging the gate posts to reposition them or by entering a

Start and Stop division on the Gate right-hand dialog..

9. Check On to enable the parameter and add it to the measurement readout table.

10. Check Show Table to display the readout on screen.

922499 Rev B