Operators Manual Owner manual

Operator's Manual
Set Up WaveScan
This procedure explains how to set up WaveScan to search an acquisition for events of interest. Set up
your source channel and triggers before setting up the scan.
1. Press the Front Panel Stop button to stop acquisition.
2. Choose Analysis > WaveScan.
3. Check Enable.
4. Choose the Source waveform.
5. Choose the Scan Mode and enter values for any additional settings that appear at the right of the
dialog based on your selection.
6. If you're using Measurement Mode, set up the filter in one of the following ways:
l Touch Filter and choose an operator, then enter the Filter Limit.
l Touch Filter Wizard and choose one of the pre-set filters. The Filter and Filter Limit are auto-
matically set based on your selection.
7. Select each Scan View in which you wish to display results by checking the box at the bottom of the
dialog. Each view selected is displayed simultaneously.
8. If you're using Scan Overlay view, on the Scan Overlay dialog Clear Sweeps. If desired, set up the Per-
sistence display.
9. Optionally, choose an Action to trigger when an event that meets your scan criteria is found.
10. Restart acquisition.
922499 Rev B
91