Instruction Manual

Operator's Manual
918800 RevA
Show Decode
Note: If you do not have the MIPI D-PHY Serial Decode Option (D PHY-D), you won't see the Show Decode
checkbox beneath the Enable checkbox. Marking this checkbox (when you have the option) shows annotations
on your waveforms.
Setup Acquisition
The Setup Acquisition button automatically makes the following settings. The settings are largely based on your
LP (Low Power) or HS (High Speed) mode selection on the Mode and Input Selection Area of the MIPI D-PHY
Dialog (on page 6).
SETUP ACQUISITION FOR LP LOW POWER MODE
Your channels are set to 200 mV/div, -600 mV offset, and a Qualified-Pattern trigger is applied to the signal for
capturing the ULPS sequence.
SETUP ACQUISITION FOR HS HIGH SPEED MODE
Your channels are set to 200 mV/div, -600 mV offset, and an Edge trigger is applied to the signal.