Datasheet

ADP300
ADP305
Datasheet
LEADING
SPECIFICATIONS
• 20 MHz and
100 MHz
bandwidth
• 1,000 V
RMS
common mode
voltage
• 1,400 V
peak
differential
voltage
• EN61010 Cat III
• 80dB CMRR at
50/60 Hz
• ProBus
®
system
• Full remote
control
• Compatible with
Waverunner
™
and
LC scopes
LeCroy
Digital Oscilloscopes
G e t t h e C o m p l e t e P i c t u r e
ADP30X high-voltage active differential pro b e s
a re safe, easy-to-use probes ideally suited for
measuring power electronics. The ADP300 is
good for troubleshooting low - f requency powe r
devices and other circuits where the re f e re n c e
potential is elevated from ground or the location
of ground is unknown. The ADP305 is designed
for measuring the high-speed floating vo l t a g e s
found in today’s high-speed power electro n i c s .
E
A S Y-TO- US E
With the Pro Bu s
®
i n t e rface, the ADP30X
becomes an integral part of the oscilloscope.
The attenuation, offset, and bandwidth limit are
all controlled from the oscilloscope front panel
or by using the remote control commands. T h i s
means the complete measurement setup can be
s a ved and recalled by the oscilloscope, and all
m e a s u rement values will be correct. The scope
p rovides power to the probe, so there is no need
to worry about a separate power supply or
changing batteries.
A
U TO Z E RO
The ADP30X offset can be easily set to zero
by pushing a button in the oscilloscope’s
coupling menu, even when connected to live
circuits. This makes it easy to get accurate
measurements.
M
E E TS EN61010 CAT E G O RY
I I I RE QU I R E M E N TS
Safety is the top priority when you work
around high-voltage signals. The ADP300 and
ADP305 are both designed to the standards
required for Installation Category III. This
means in addition to being used on appliances
and portable equipment (Cat II), they can be
used in fixed-installation environments.