User Manual

Instruction Manual
Do not overload. Do not apply any potential to the probe leads that exceeds the
maximum rating of the probe. Always comply with the Voltage vs. Frequency
Derating Curve.
Observe all terminal ratings. Observe all markings on the oscilloscope before
connecting. Consult the oscilloscope product manual for further ratings
information.
Do not remove probe casing. Touching exposed connections may result in
electric shock.
Use indoors only within operational environment listed. Do not use in wet or
explosive atmospheres. Keep product surfaces clean and dry.
Handle with care. Probe tips are extremely sharp and may puncture skin or
cause other bodily injury if not handled properly.
Keep fingers behind the finger guard of probe body and accessories.
Do not operate with suspected failures. Before each use, inspect the probe and
accessories for any potential damage such as tears or other defects in the probe
body, cable jacket, accessories, etc. If any part is damaged, cease operation
immediately and sequester the probe from inadvertent use.
Cleaning
• Clean only the exterior of the probe, cables, and accessories. Use a soft
cotton cloth moistened with a mild detergent and water solution. Do not
allow any portion of the probe to be submerged at any time.
• Dry the probe and accessory thoroughly before attempting to make any
voltage measurement.
• Do not subject the probe to solvents or solvent fumes as these can cause
deterioration of the probe body, cables, and accessories.
923445-00 Rev A 5