Manual
Manuals
Brands
Teledyne LeCroy Manuals
Software
QPHY-10GBase-KR
19
20
21
22
23
24
25
26
27
28
Table Of Contents
Introduction
About QualiPHY
About QPHY-10GBase-KR
Required Equipment
Required Host Computer System
Install Base Application
Activate Components
Set Up Dual Monitor Display
Set Up Remote Control
Configure Oscilloscope for Remote Control
Add Connection to QualiPHY
Select Connection
Accessing the Software
General Setup
Connection tab
Session Info tab
Report tab
Advanced tab
About tab
QualiPHY Test Process
Set Up Test Session
Run Tests
Run Reports
Customizing QualiPHY
Copy Configuration
Select Tests
Edit Variables
Edit Test Limits
X-Replay Mode
QPHY-10GBase-KR Testing
Test Preparation
QPHY-10GBase-KR Test Configurations
DEMO Mode
Run Live with Pauses, Single Ended Inputs on row A
QPHY-10GBase-KR Test Descriptions
Jitter: Tj, Rj, Dj, DCD & BitRate
Voltage Measurements Single Ended – on 0101
Voltage Measurements Differential – on 0101
Transition Time Test
TX Output Waveform Tests
QPHY-10GBase-KR Variables
Acquire Live Data
Demo Mode
Differential Signal Source
Input Row
Save Waveform Path
Save Waveforms
Signal Is Differential
Signal Source N
Signal Source P
Stop on Test
Specific to Jitter and Voltage Tests
Test Pattern for Jitter
QPHY-10GBase-KR Limit Sets
Manual Deskewing Procedures
Cable Deskewing Using the Fast Edge Output
Cable Deskewing Without Using the Fast Edge Output
Error Messages
1
...
...
26
27
28
