Instruction Manual

QPHY-MOST50e Software Option
920457 Rev B 5
INTRODUCTION TO QUALIPHY MOST50 EPHY
QPHY-MOST50e is an automated test package performing all of the normative real time oscilloscope
tests for sources in accordance with the MOST Electrical Physical Layer Specification Rev. 1.1,
06/2006, Version 1.1-00. The software can be run on any LeCroy Zi and Xi Series oscilloscope with at
least 500 MHz bandwidth, a sample rate of at least 5GSa/s, and 10Mpt of memory. The oscilloscope
must also be equipped with the QPHY-MOST50e, DFP2, and either SMD or SDA2 options.
Required Equipment
• QPHY-MOST50e, DFP2, and either SDM or SDA2 options
• Real time LeCroy Oscilloscope meeting the above requirements (at least 500 MHz bandwidth,
a sample rate of at least 5GSa/s, and 10Mpt of memory)
o All LabMaster 9 Zi-A and SDA/DDA/WaveMaster 8 Zi-A oscilloscopes
o SDA/DDA/WavePro 725Zi-A and higher bandwidth oscilloscopes
o WaveRunner 606 Zi and higher bandwidth oscilloscopes
o WaveRunner 64 MXi-A /Xi-A Series and higher bandwidth oscilloscopes
Note: If a WaveRunner Xi oscilloscope is being used, the XWEB option is additionally
required.
• LeCroy ZD1000 Differential Probe or greater (for electrical measurements)