Owner manual

TA660 User's Manual Catalyst Enterprises, Inc

Adding and Removing Signals for Display

All PCI bus signals are always captured and stored on disc, but may

not necessarily be displayed as default unless selected. For a signal to

be viewed you must make sure that it is included for display. The

capability to add or remove signals from the display offers you the

ability to make the display less cluttered by including only the signals

of current interest.

All signals stored Adding and removing signals is a display function only. All

captured data are saved in the output file on the hard disc

and is available for display by including the signal name on

the setup screen.

To add a signal to an open display:

Click the Setup Screen button to open the Active Signals dialog box.

Figure 88 Active Signals Dialog Box

Find the signal to be added in the Remaining Signals area and click

Add. To find signals quicker the signals are grouped in several

classifications. When you select a group, all of the signals of that

group display in the Remaining Signals window. Conversely you may

remove signals from the Active Signals window by highlighting them

and clicking Remove. When done click OK. The signals are always

added to the end of the display but they may be dragged by the mouse

to the desired location in the display for viewing.

Quick Signal Edit To quickly add or remove signals from the display, right

click the mouse in the signal name area.