Owner manual

TA660 User's Manual Catalyst Enterprises, Inc

Figure 90 Signal Color Selection Dialog

Latency Report

To view Master/Target Latencies add the signals LAT_XX to the

display See Figure 88.

Using the Cursors

Each of the data displays incorporates three cursors that are labeled X,

Y and T. All of them are initially overlaid and positioned at location

0, which is the trigger position of the display. The Trigger or T cursor

is always locked at location 0 of the display. It cannot be repositioned.

and serves as the measurement reference.

Moving the X Cursor The X cursor may be dragged by selecting the left mouse

button and positioning the mouse cursor over the display

cursors and then dragging to the desired location or by

clicking the left mouse button with the mouse cursor

positioned anywhere in the display. This will cause a

display in the [X-T](XRef-Trig) box to show the difference

in clocks, or, if selected, time, between the trigger and the X

cursor.

Moving the Y Cursor Similarly the Y cursor may be dragged by positioning the

mouse cursor over the cursors with the right mouse button

selected or by clicking the right mouse button with the

mouse cursor anywhere in the display. This will cause a

display in the [Y-T](YRef-Trig) box to show the difference