Owner manual

TA660 User's Manual Catalyst Enterprises, Inc

Installing Your Analyzer

Hardware Installation

1. Make sure that the Target Machine is powered down.

2. Remove the case from your machine in accordance with the

instructions supplied for it.

3. Install the Analyzer card in any available PCI slot and secure the

mounting bracket to the chassis with the mounting screw.

Warning: Make sure to take precautions to avoid static electricity

discharge damage to the Analyzer Card by using a

grounding strap or touching a grounded metal surface just

prior to handling the analyzer card. Avoid touching any

components and handle card by the edges only.

4. Interconnect the Analyzer DB-25 connector to the Host system Bi-

directional parallel port using the provided DB-25 pin cable.

Host and Target Same The Analyzer may be used in a configuration such that the

Host and Target are the same machine.

Bi-Directional Port The Analyzer requires that The Host parallel port support

Bi-directional data transfers. See LPT Port Setting for

verifying that your parallel port supports and/or is set to a

Bi-directional mode. If the parallel port on your Host

system does not support Bi-directional data transfers you

must then install the parallel port card supplied with your

analyzer in a spare ISA slot and connect to it.

Port Configuration The parallel port card supplied with your analyzer is pre

configured for LPT2 (H278). If the Host system is using this

address for its printer port, you must then change the jumper

configuration on the ISA parallel card to H378 (LPT1).