Owner manual

TA660 User's Manual Catalyst Enterprises, Inc
6
Software Installation
On systems operating under Windows 95, 98, NT or 2000:
1. Insert the CD ROM.
2. The installation will automatically start the setup unless the auto Run
is turned off, in that case select the CDROM from “My Computer”
and click on setup.
3. After the warning for closing all other programs and before starting
the installation, the Install Component selection window will open as
shown in Figure 4.
Windows NT If you are operating under Windows NT, be sure to select
the NT driver for installation. If the host system operating
software is not Windows NT, this selection will be
automatically Deselected.
Figure 4 Install Component Selection
4. Select the desired components for installation.
5. Click Next to complete the installation.
NT driver Restart If you installed the NT driver you must restart your
computer before you can use your analyzer software.
Error Message If you get an error message during installation of the NT
driver consult your system administrator. Your system may