Owner manual

TA660 User's Manual Catalyst Enterprises, Inc
132
Troubleshooting
Hardware not Found
When launching your TA660 Analyzer, a Hardware Not Found may
be indicative of a problem with your parallel port. Make sure to check
your LPT Port settings as described in LPT Port Setting on page 13 .
No Trigger
If after clicking Run the analyzer does not trigger for a long time.
Click Stop in the Waiting for data. . . dialog to open the data capture
display window.
A display with only two captured locations may be indicative of a
BIOS that views your card as transparent to the slot used and shuts off
the clock to that slot.
To correct this condition go to your CMOS setup and check the
options for “PCI clock Enable/Disable” and disable the option.