Owner manual

TA660 User's Manual Catalyst Enterprises, Inc

Data Capture Options

Memory Display You may limit the captured data display to a specific

number of samples by checking Partial Memory and

entering the number of Samples to be captured or, you may

check entire memory to allow the capture for the entire

memory.

Pre-Trigger Pre-Trigger is set by default at 50% which defines the

percentage of data to be captured before and after the

triggering event. You may change this percentage by

dragging the slider to the desired value.

Pre-Trigger Data: The capture of the specified percentage of the data prior to

the triggering event cannot be guaranteed and may in some

cases be 0. This can occur in cases where the triggering

event occurs before the required number pre-trigger event

data can be stored. In these cases the data display will show

fewer than the specified data points prior to the triggering

event. For more detail see Set Trigger on page 69.

Manual Trigger Select this option when you wish to manually interrupt the

data capture based on some external event. With this option

selected, data will be continually captured to memory and

overwritten as required until you stop the data capture.

Continuous Mode Continually captures data for the number of times specified.

A separate data file is generated each time that a capture is

performed.

Exclude Cycles To simplify the captured data display you may check the

options to exclude, Idles, Wait States and Retries.